Spectroscopic Investigation of Level Population of Sputtered Tungsten in the Linear Plasma Device PSI-2

Tungsten (W) is foreseen as plasma-facing material in future fusion reactors. Spectroscopy is an important means for particle flux measurements in the plasma. For an interpretation of the measured neutral W line (W I) intensities, the population distribution of J levels within the fivefold ground term⁵D and the⁷S₃level of sputtered tungsten entering the plasma remains an open question [1]. Therefore, W targets were exposed to plasma in the linear plasma device PSI-2 and sputtering of the material was spectroscopically investigated. The spatial distance in between the target and the position of the intensity maximum of the line provides information about the temporal level evolution. This correlation was used to investigate the atomic level distribution of the sputtered tungsten.

Experimental Setup

The experiments took place in the linear plasma device PSI-2 [2]. A schematic setup is shown in figure 1.

Fig.1: The linear plasma device PSI-2 with the optical observation system.

阿克顿光谱仪SpectraPro 750牛顿EMCCD detector DU971P-UVB was used for spectroscopic analyses of processes in PSI-2. Due to a rotating mirror system the slit can be orientated horizontally, i.e. orthogonal to the target surface, to observe the time dependent development of the eroded species. A picture of the plasma and the exposed target is shown in figure 2.

Fig.2: W target exposed to Argon plasma using the side manipulator.

An additional lens system was used to increase the spatial resolution to 50 µm per pixel. This leads to an overall spatial spectra observation of 20 mm along the axis. The W target was exposed to an Argon plasma at T_e≈ 2 eV and n_e≈ 7x10¹¹cm^-3and the development of the line intensities was observed. The plasma ions were accelerated by biasing onto the target to an impact energy of around 80 eV. The spectra were taken in the first order so the dispersion per pixel on the Newton EMCCD was in the order of 0.016 nm. Thus the spectral width of approximately 25 nm could be detected with one picture. The dynamical range of the camera allowed to observe all investigated lines with an exposure time of 10 s using the conventional CCD mode.

Analysis and Results

The lifetime of the excited level is equal to the reciprocal Einstein coefficient (A). The mean velocity of the sputtered particles (v_mean) for an impact energy of Argon of 80 eV is approximately 2500 m/s [3]. Assuming an angular distribution of the sputtered atoms [4], the distance to the target for the maximum intensity is given by d ≈ v_mean/(2A). In figure 3 the spatial developments of two W I lines are shown.

Fig.3: Spatial behaviour of a 5D0 line compared to a 7S3 line. The dashed lines give the expected points for the maxima of emission. The bottom picture shows the target recorded with the spectrometer in the zeroth order and open slit.

It can be seen that the transition to the ground level (498.26 nm) is in good agreement with the expected value, whereas the most popular tungsten line (400.88 nm), that is ending in the slightly more energetic⁷S₃level, is at its maximum intensity at a larger distance and hence later than expected. Other transitions to the ground states are compared to the calculated position of maximum intensity in figure 4.

Fig.4: The detected position of maximum emission for the lower level of the investigated transition compared the theoretical value for a mean velocity of 2500 m/s.

Just the line to the ground level is in good agreement with the theory, all other lines reach the maximum at a larger distance from the target than expected. Thus the data suggests that at a mono-energetic ion energy in the range of 100-200 eV, set by target biasing, all atoms are sputtered primarily in the lowest ground level⁵D₀. Other levels are populated subsequently in the plasma.

References

[1] Beigman et al. Plasma Phys. Control. Fusion49, 1833 (2007)

[2] A. Kreter et al. Fusion Science and Technology68, 8-14 (2015)

[3] W. Eckstein IPP-Report (2002)

[4] M. Stepanova et al. Journal of Vacuum Science & Technology A: Vacuum, Surfaces, and Films19, 2805 (2001)

Contact

Dr. Sebastijan Brezinsek
Institute of Energy and Climate Research
Plasma Physics
Forschungszentrum Jülich GmbH
52425 Jülich
Germany

Phone: +49 (2461) 61-6611
E-mail:s.brezinsek@fz-juelich.de
Web:https://www.fz-juelich.de/iek/iek-4/EN/Home/home_node.html